Linux version 2.6.22 (linuxguy@intrepid) (gcc version 4.1.2) #69 Fri Feb 8 15:19:05 PST 2008 CPU: ARM920T [41129200] revision 0 (ARMv4T), cr=c0007177 Machine: TCT_HAMMER Memory policy: ECC disabled, Data cache writeback On node 0 totalpages: 8192 DMA zone: 64 pages used for memmap DMA zone: 0 pages reserved DMA zone: 8128 pages, LIFO batch:0 Normal zone: 0 pages used for memmap CPU S3C2410A (id 0x32410002) S3C2410: core 202.800 MHz, memory 101.400 MHz, peripheral 50.700 MHz S3C24XX Clocks, (c) 2004 Simtec Electronics CLOCK: Slow mode (1.500 MHz), fast, MPLL on, UPLL on CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets CPU0: D cache: 16384 bytes, associativity 64, 32 byte lines, 8 sets Built 1 zonelists. Total pages: 8128 Kernel command line: console=ttySAC0 root=/dev/ram0 irq: clearing subpending status 00000002 PID hash table entries: 128 (order: 7, 512 bytes) timer tcon=00000000, tcnt a509, tcfg 00000200,00000000, usec 00001e4c selected clock c01df178 (pclk) quot 27, calc 113169 Dentry cache hash table entries: 4096 (order: 2, 16384 bytes) Inode-cache hash table entries: 2048 (order: 1, 8192 bytes) Memory: 32MB = 32MB total Memory: 27388KB available (1736K code, 159K data, 92K init) Calibrating delay loop... 101.17 BogoMIPS (lpj=252928) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 S3C2410: Initialising architecture NET: Registered protocol family 23 NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 0, 4096 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP reno registered checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 3072K NetWinder Floating Point Emulator V0.97 (extended precision) audit: initializing netlink socket (disabled) audit(2.270:1): initialized io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered Non-volatile memory driver v1.2 s3c2410-uart.0: s3c2410_serial0 at MMIO 0x50000000 (irq = 70) is a S3C2410 s3c2410-uart.1: s3c2410_serial1 at MMIO 0x50004000 (irq = 73) is a S3C2410 s3c2410-uart.2: s3c2410_serial2 at MMIO 0x50008000 (irq = 76) is a S3C2410 RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize loop: module loaded nbd: registered device at major 43 tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky dm9000 Ethernet Driver physmap platform flash device: 01000000 at 00000000 physmap-flash.0: Found 1 x16 devices at 0x0 in 16-bit bank Intel/Sharp Extended Query Table at 0x0031 Using buffer write method cfi_cmdset_0001: Erase suspend on write enabled erase region 0: offset=0x0,size=0x20000,blocks=128 cmdlinepart partition parsing not available RedBoot partition parsing not available Using physmap partition information Creating 2 MTD partitions on "physmap-flash.0": 0x00000000-0x00400000 : "System" mtd: Giving out device 0 to System 0x00400000-0x01000000 : "JFFS2" mtd: Giving out device 1 to JFFS2 i2c-core: driver [ds1307] registered i2c /dev entries driver i2c-core: driver [dev_driver] registered IPv4 over IPv4 tunneling driver TCP cubic registered NET: Registered protocol family 1 NET: Registered protocol family 15 drivers/rtc/hctosys.c: unable to open rtc device (rtc0) RAMDISK: Compressed image found at block 0 length error VFS: Mounted root (ext2 filesystem) readonly. Freeing init memory: 92K selected clock c01df178 (pclk) quot 27, calc 113169 selected clock c01df178 (pclk) quot 27, calc 113169 usbcore: registered new interface driver usbfs usbcore: registered new interface driver hub usbcore: registered new device driver usb ohci_hcd: 2006 August 04 USB 1.1 'Open' Host Controller (OHCI) Driver s3c2410-ohci s3c2410-ohci: S3C24XX OHCI s3c2410-ohci s3c2410-ohci: new USB bus registered, assigned bus number 1 s3c2410-ohci s3c2410-ohci: irq 42, io mem 0x49000000 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 2 ports detected SCSI subsystem initialized usb 1-1: new full speed USB device using s3c2410-ohci and address 2 usb 1-1: configuration #1 chosen from 1 choice hub 1-1:1.0: USB hub found hub 1-1:1.0: 4 ports detected usb 1-1.1: new full speed USB device using s3c2410-ohci and address 3 usb 1-1.1: no configurations usb 1-1.1: can't read configurations, error -22 usb 1-1.1: new full speed USB device using s3c2410-ohci and address 4 usb 1-1.1: configuration #1 chosen from 1 choice usb 1-1.2: new full speed USB device using s3c2410-ohci and address 5 usb 1-1.2: configuration #1 chosen from 1 choice usb 1-1.3: new full speed USB device using s3c2410-ohci and address 6 usb 1-1.3: configuration #1 chosen from 1 choice usb 1-1.4: new full speed USB device using s3c2410-ohci and address 7 usb 1-1.4: configuration #1 chosen from 1 choice usbcore: registered new interface driver libusual Initializing USB Mass Storage driver... scsi0 : SCSI emulation for USB Mass Storage devices usbcore: registered new interface driver usb-storage USB Mass Storage support registered. usb-storage: device found at 6 usb-storage: waiting for device to settle before scanning usb-storage: device scan complete scsi 0:0:0:0: Direct-Access PNY USB 2.0 FD PMAP PQ: 0 ANSI: 0 CCS sd 0:0:0:0: [sda] 4030464 512-byte hardware sectors (2064 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00 sd 0:0:0:0: [sda] Assuming drive cache: write through sd 0:0:0:0: [sda] 4030464 512-byte hardware sectors (2064 MB) sd 0:0:0:0: [sda] Write Protect is off sd 0:0:0:0: [sda] Mode Sense: 23 00 00 00 sd 0:0:0:0: [sda] Assuming drive cache: write through sda: sda1 sd 0:0:0:0: [sda] Attached SCSI removable disk EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended s3c2410_udc: debugfs dir creation failed -19 ether gadget: using random self ethernet address ether gadget: using random host ethernet address usb0: Ethernet Gadget, version: May Day 2005 usb0: using s3c2410_udc, OUT ep2-bulk IN ep1-bulk STATUS ep3-bulk usb0: MAC 66:f6:39:ae:11:7a usb0: HOST MAC 26:f5:6d:e0:c8:66 usb0: RNDIS ready usbcore: registered new interface driver irda-usb USB IrDA support registered selected clock c01df178 (pclk) quot 27, calc 113169 selected clock c01df178 (pclk) quot 27, calc 113169 selected clock c01df178 (pclk) quot 27, calc 113169 selected clock c01df178 (pclk) quot 27, calc 113169 #