ehci_platform ehci_platform.16781: EHCI Host Controller ehci_platform ehci_platform.16781: new USB bus registered, assigned bus number 2 ehci_platform ehci_platform.16781: irq 12, io mem 0x00000000 ehci_platform ehci_platform.16781: park 0 ehci_platform ehci_platform.16781: USB 0.0 initialized, EHCI 1.00, driver 10 Dec 2004 hub 2-0:1.0: USB hub found hub 2-0:1.0: 1 port detected USB Universal Host Controller Interface driver v2.2 usbcore: registered new driver usblp drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver Initializing USB Mass Storage driver... usbcore: registered new driver usb-storage USB Mass Storage support registered. mice: PS/2 mouse device common for all mice MICON ctrl (C) BUFFALO INC. V.1.00 installed. Kernel event proc (C) BUFFALO INC. V.1.00 installed. MICON V2 (C) BUFFALO INC. V.1.00 installed. NET: Registered protocol family 2 IP: routing cache hash table of 1024 buckets, 8Kbytes TCP established hash table entries: 8192 (order: 4, 65536 bytes) TCP bind hash table entries: 8192 (order: 3, 32768 bytes) TCP: Hash tables configured (established 8192 bind 8192) NET: Registered protocol family 1 NET: Registered protocol family 17 RAMDISK: Compressed image found at block 0 EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended VFS: Mounted root (ext2 filesystem). ---- in Modified linuxrc --- Mon Feb 11 18:35:21 JST 2008 err: >AnalyzeRecvPacket:This is invalid RespCode.(code=244) kjournald starting. Commit interval 5 seconds EXT3 FS on sda1, internal journal EXT3-fs: recovery complete. EXT3-fs: mounted filesystem with ordered data mode. linuxrc:choose operation (timeout 4[s]) 1:RamRoot other:HddRoot ? -HddRoot- *** not found /boot/rootfs_ok file in rootfs. *** chars= 1 KERNEL:2006/12/5 22:22:58 HDD:2007/6/28 9:42:0 Bypassing CopyFromInitrdToHdd checking local disk.... fsck 1.27 (8-Mar-2002) e2fsck 1.27 (8-Mar-2002) /dev/ls_disk1_1: clean, 21/74296 files, 24548/297171 blocks done XFS mounting filesystem sda2 Starting XFS recovery on filesystem: sda2 (dev: sda2) Ending XFS recovery on filesystem: sda2 (dev: sda2) VFS: Mounted root (xfs filesystem). Trying to move old root to /initrd ... okay Freeing init memory: 112K INIT: version 2.86 booting * udev requires a kernel >= 2.6.15, not started. failed! Setting parameters of disc: (none). Activating swap:swapon on /dev/sda5 Adding 136512k swap on /dev/sda5. Priority:-1 extents:1 . Setting the system clock again.. System Clock set. Local time: Mon Feb 11 18:35:31 UTC 2008. Cleaning up ifupdown.... Loading device-mapper support. Will now check all file systems. fsck 1.40-WIP (14-Nov-2006) Checking all file systems. [/sbin/fsck.ext3 (1) -- /boot] fsck.ext3 -y -C0 /dev/sda1 e2fsck 1.40-WIP (14-Nov-2006) /dev/sda1: clean, 21/74296 files, 24548/297171 blocks (check in 4 mounts) Done checking file systems. A log is being saved in /var/log/fsck/checkfs if that location is writable. Setting kernel variables...done. Will now mount local filesystems:mount: none already mounted or /dev/pts busy mount: according to mtab, devpts is already mounted on /dev/pts kjournald starting. Commit interval 5 seconds EXT3 FS on sda1, internal journal EXT3-fs: mounted filesystem with ordered data mode. XFS mounting filesystem sda6 failed! Will now activate swapfile swap:done. Cleaning /tmp...done. Setting up resolvconf...done. Setting up networking.... * /etc/network/options is deprecated (see README.Debian of netbase). Setting up IP spoofing protection...done (rp_filter). Configuring network interfaces...There is already a pid file /var/run/dhclient.eth0.pid with pid 1073908416 Internet Systems Consortium DHCP Client V3.0.4 Copyright 2004-2006 Internet Systems Consortium. All rights reserved. For info, please visit http://www.isc.org/sw/dhcp/ Listening on LPF/eth0/00:16:01:bc:62:5c Sending on LPF/eth0/00:16:01:bc:62:5c Sending on Socket/fallback DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 4 DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 9 DHCPDISCOVER on eth0 to 255.255.255.255 port 67 interval 8 ## Booting image at 00100000 ... Image Name: Linux-2.6.12.6-arm1 Created: 2006-12-06 4:23:49 UTC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 1941956 Bytes = 1.9 MB Load Address: 00008000 Entry Point: 00008000 Verifying Checksum ... OK OK ## Loading Ramdisk Image at 00800000 ... Image Name: initrd Created: 2006-12-27 21:19:31 UTC Image Type: ARM Linux RAMDisk Image (gzip compressed) Data Size: 4563515 Bytes = 4.4 MB Load Address: 00000000 Entry Point: 00000000 Verifying Checksum ... OK Starting kernel ... arg:console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.10 CONFIG_BUFFALO_PLATFORM CONFIG_BUFFALO_LINKSTATION_LSGL --- Uncompressing Linux.............................................................................................................................. done, booting the kernel. Linux version 2.6.12.6-arm1 (root@Desktop) (gcc version 3.4.4 (release) (CodeSourcery ARM 2005q3-2)) #77 Tue Dec 5 22:23:46 CST 2006 CPU: ARM926EJ-Sid(wb) [41069260] revision 0 (ARMv5TEJ) CPU0: D VIVT write-back cache CPU0: I cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets CPU0: D cache: 32768 bytes, associativity 1, 32 byte lines, 1024 sets Machine: MV-88fxx81 Using UBoot passing parameters structure Sys Clk = 200000000, Tclk = 166664740 - Warning - This LSP release was tested only with U-Boot release 1.7.3 Memory policy: ECC disabled, Data cache writeback Built 1 zonelists Kernel command line: console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.10 PID hash table entries: 1024 (order: 10, 16384 bytes) Console: colour dummy device 80x30 Dentry cache hash table entries: 32768 (order: 5, 131072 bytes) Inode-cache hash table entries: 16384 (order: 4, 65536 bytes) Memory: 128MB 0MB 0MB 0MB = 128MB total Memory: 110208KB available (3370K code, 570K data, 112K init) Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok checking if image is initramfs...it isn't (no cpio magic); looks like an initrd Freeing initrd memory: 15360K NET: Registered protocol family 16 FLASH boardId = 12 Flash bankwidth 1, base ff800000, size 400000 BUFFALO LS_GL FLASH size 4096[KB] Marvell Development Board (LSP Version 1.7.8_NAS)-- BUFFALO_BOARD_LS_GL Detected Tclk 166664740 and SysClk 200000000 Marvell USB EHCI Host controller #0: c1702bc0 Marvell USB EHCI Host controller #1: c1702980 pexBarOverlapDetect: winNum 2 overlap current 0 mvPexInit:Warning :Bar 2 size is illigal it will be disabled please check Pex and CPU windows configuration PCI: bus0: Fast back to back transfers enabled PCI: bus1: Fast back to back transfers enabled SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub use IDMA acceleration in copy to/from user buffers. used channels 2 and 3 Done. cesadev_init(c0011304) mvCesaInit: sessions=640, queue=32, pSram=f0000000 Fast Floating Point Emulator V0.9 (c) Peter Teichmann. VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) Installing knfsd (copyright (C) 1996 okir@monad.swb.de). SGI XFS with no debug enabled Initializing Cryptographic API Serial: 8250/16550 driver $Revision: 1.90 $ 4 ports, IRQ sharing disabled No DHCPOFFERS received. No working leases in persistent database - sleeping. ttyS0 at MMIO 0x0 (irq = 3) is a 16550A ttyS1 at MMIO 0x0 (irq = 4) is a 16550A io scheduler noop registered io scheduler anticipatory registered io scheduler deadline registered io scheduler cfq registered RAMDISK driver initialized: 3 RAM disks of 16384K size 1024 blocksize loop: loaded (max 8 devices) Marvell Gigabit Ethernet Driver 'egiga': o Ethernet descriptors in DRAM o DRAM SW cache-coherency o Checksum offload enabled o Loading network interface ** egiga_init_module (0) 'eth0' Intergrated Sata device found scsi0 : Marvell SCSI to SATA adapter scsi1 : Marvell SCSI to SATA adapter Vendor: SAMSUNG Model: HD501LJ Rev: CR10 Type: Direct-Access ANSI SCSI revision: 03 SCSI device sda: 976773168 512-byte hdwr sectors (500108 Mdone. ....Bringing up static interface Start services: micro_evtd Starting portmap daemon.... Starting kernelmon:Initializing random number generator...done. INIT: Entering runlevel: 2 Starting system log daemon: syslogd. Starting kernel log daemon: klogd. Starting portmap daemon...Already running.. Updating the operating system logo...done. Exporting directories for NFS kernel daemon.... Starting NFS kernel daemon: nfsd mountd. * Not starting internet superserver: no services enabled. Starting Samba daemons: nmbd smbd. Starting OpenBSD Secure Shell server: sshd. Starting NFS common utilities: statd idmapd. Starting periodic command scheduler: crond. Running local boot scripts (/etc/rc.local). BUFFALO INC. LinkStation series LS-GL(IESADA) LS-GL7D6 login: