Version 1.0.1
Read EEPROM
Jump to Flash


U-Boot 2.1.09-8.16 Vinetic-2VIP#GARY(safe timing) (Dec 13 2007 - 10:11:45)

DRAM:  16 MB

Head: relocate_code start
Head: relocate code finish.
   Image Name:   u-boot image
   Image Type:   MIPS Linux Firmware (lzma compressed)
   Data Size:    40306 Bytes = 39.4 kB
   Load Address: 80100000
   Entry Point:  80100000
Disabling all the interrupts
   Uncompressing UBoot Image ...
   Uncompression completed successfully with destLen 132832.
Head: Jumping to u-boot in the ram at 0x80100000

In env_init : env_ptr = 0xb3010000
For enviornment CRC32 is OK
Board: AMAZON Yangtse Version, Chip V1.3, CPU Speed 235 MHz
DRAM:  16 MB

 relocate_code start
 relocate code finish

Entering flash_init()
Flash:  8 MB
env_relocate[247] malloced ENV at 80ab0008
env_relocate finished

Initialize devices...
In:    serial
Out:   serial
Err:   serial
Net:   reset switch

ADM6996 SMI Mode-Chip ID:71023
 AMAZON Switch
Saving ubootconfig ...
Erasing Flash from B3010000 to B301FFFF ...
Done
Writing to Flash to B3010000 from buffer 80AB0008 with length 00010000 ... Done

Type "run flash_nfs" to mount root filesystem over NFS

   Verifying Checksum ... OK
   Uncompressing Kernel Image ... Uncompression time : 259423/117500000
Uncompression length is 1961984
OK

Starting kernel ...

Yangtse Version