lspci -v
-------------------------------------------------------------------------------------------------------------
00:0b.0 IDE interface: Netcell Corporation Revolution Storage Processing Card (prog-if 85 [Master SecO PriO])
        Subsystem: Netcell Corporation Revolution Storage Processing Card
        Flags: bus master, 66MHz, medium devsel, latency 32, IRQ 177
        I/O ports at c000 [size=8]
        I/O ports at bc00 [size=4]
        I/O ports at b800 [size=8]
        I/O ports at b400 [size=4]
        I/O ports at b000 [size=16]
        Expansion ROM at febe0000 [disabled] [size=8K]
-------------------------------------------------------------------------------------------------------------

dmesg (cutted)
-------------------------------------------------------------------------------------------------------------
[...]
Revolution: chipset revision 0
Revolution: 100% native mode on irq 177
Revolution: simplex device: DMA forced
    ide2: BM-DMA at 0xb000-0xb007, BIOS settings: hde:DMA, hdf:DMA
Revolution: simplex device: DMA forced
    ide3: BM-DMA at 0xb008-0xb00f, BIOS settings: hdg:DMA, hdh:DMA
Probing IDE interface ide2...
usbcore: registered new driver usbfs
usbcore: registered new driver hub
USB Universal Host Controller Interface driver v3.0
hde: NetCell SyncRAID(TM) SR5010 JBOD, ATA DISK drive
ide2 at 0xc000-0xc007,0xbc02 on irq 177
Probing IDE interface ide3...
VP_IDE: IDE controller at PCI slot 0000:00:0f.1
ACPI: PCI Interrupt 0000:00:0f.1[A] -> GSI 20 (level, low) -> IRQ 185
PCI: VIA IRQ fixup for 0000:00:0f.1, from 255 to 9
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
VP_IDE: VIA vt8237 (rev 00) IDE UDMA133 controller on pci0000:00:0f.1
    ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:DMA
Probing IDE interface ide0...
SCSI subsystem initialized
libata version 2.00 loaded.
hde: max request size: 512KiB
hde: 976773168 sectors (500107 MB), CHS=60801/255/63, (U)DMA
hde: set_geometry_intr: status=0x51 { DriveReady SeekComplete Error }
hde: set_geometry_intr: error=0x04 { DriveStatusError }
ide: failed opcode was: 0xef
hde: cache flushes supported
[...]
-------------------------------------------------------------------------------------------------------------