cx88/0: cx2388x v4l2 driver version 0.0.6 loaded
PCI: Enabling device 0000:00:0b.0 (0004 -> 0006)
ACPI: PCI Interrupt 0000:00:0b.0[A] -> GSI 19 (level, low) -> IRQ 19
cx88[0]: subsystem: 1822:0023, board: Twinhan VP-1027 DVB-S [card=59,autodetected]
cx88[0]: TV tuner type 4, Radio tuner type -1
cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
input: PC Speaker as /class/input/input2
cx88[0]/0: found at 0000:00:0b.0, rev: 5, irq: 19, latency: 32, mmio: 0xe7000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
cx88[0]/2: cx2388x 8802 Driver Manager
ACPI: PCI Interrupt 0000:00:0b.2[A] -> GSI 19 (level, low) -> IRQ 19
cx88[0]/2: found at 0000:00:0b.2, rev: 5, irq: 19, latency: 32, mmio: 0xe8000000
cx88/2: cx2388x dvb driver version 0.0.6 loaded
cx88/2: registering cx8802 driver, type: dvb access: shared
cx88[0]/2: subsystem: 1822:0023, board: Twinhan VP-1027 DVB-S [card=59]
cx88[0]/2: cx2388x based DVB/ATSC card
DVB: registering new adapter (cx88[0])
DVB: registering frontend 0 (Fujitsu MB86A16 DVB-S)...
cx88[0]: video y / packed - dma channel status dump
cx88[0]:   cmds: initial risc: 0x36e7b000
cx88[0]:   cmds: cdt base    : 0x00180440
cx88[0]:   cmds: cdt size    : 0x0000000c
cx88[0]:   cmds: iq base     : 0x00180400
cx88[0]:   cmds: iq size     : 0x00000010
cx88[0]:   cmds: risc pc     : 0x36e7b034
cx88[0]:   cmds: iq wr ptr   : 0x0000010d
cx88[0]:   cmds: iq rd ptr   : 0x00000101
cx88[0]:   cmds: cdt current : 0x00000458
cx88[0]:   cmds: pci target  : 0x00000000
cx88[0]:   cmds: line / byte : 0x00000000
cx88[0]:   risc0: 0x80008200 [ sync resync count=512 ]
cx88[0]:   risc1: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   risc2: 0x36e55000 [ arg #1 ]
cx88[0]:   risc3: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq 0: 0x80008200 [ sync resync count=512 ]
cx88[0]:   iq 1: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq 2: 0x36e55000 [ arg #1 ]
cx88[0]:   iq 3: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq 4: 0x36e55280 [ arg #1 ]
cx88[0]:   iq 5: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq 6: 0x36e55500 [ arg #1 ]
cx88[0]:   iq 7: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq 8: 0x36e55780 [ arg #1 ]
cx88[0]:   iq 9: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq a: 0x36e55a00 [ arg #1 ]
cx88[0]:   iq b: 0x1c000280 [ write sol eol count=640 ]
cx88[0]:   iq c: 0x36e55c80 [ arg #1 ]
cx88[0]:   iq d: 0x71010000 [ jump irq1 cnt0 count=0 ]
cx88[0]:   iq e: 0xd2000001 [ arg #1 ]
cx88[0]:   iq f: 0x0031c040 [ INVALID 21 20 cnt0 resync 14 count=64 ]
cx88[0]: fifo: 0x00180c00 -> 0x183400
cx88[0]: ctrl: 0x00180400 -> 0x180460
cx88[0]:   ptr1_reg: 0x00181228
cx88[0]:   ptr2_reg: 0x00180468
cx88[0]:   cnt1_reg: 0x0000002b
cx88[0]:   cnt2_reg: 0x00000000
cx88[0]/0: [f7226200/2] timeout - dma=0x36e7b000


Output of szap:

reading channels from file '/home/gvl2/.szap/channels.conf'
zapping to 184 '(null) - [0b9-03bf]':
sat 0, frequency = 12442 MHz H, symbolrate 20000000, vpid = 0x1fff, apid = 0x1009 sid = 0x0000
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
FE_SET_VOLTAGE failed: Operation not supported
status 00 | signal ffdd | snr ff02 | 
status 00 | signal ffdd | snr ff02 | 
status 00 | signal ffdd | snr ff02 | 
status 00 | signal ffdd | snr ff02 | 

Output of scan:

scanning /home/gvl2/SATSTUFF/119.cleaned
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 12239000 H 20000000 5
initial transponder 12268000 H 20000000 5
initial transponder 12282000 V 20000000 5
initial transponder 12297000 H 20000000 5
initial transponder 12311000 V 20000000 5
initial transponder 12326000 H 20000000 5
initial transponder 12341000 V 20000000 5
initial transponder 12355000 H 20000000 5
initial transponder 12370000 V 20000000 7
initial transponder 12384000 H 20000000 5
initial transponder 12399000 V 20000000 5
initial transponder 12414000 H 20000000 5
initial transponder 12428000 V 20000000 5
initial transponder 12443000 H 20000000 5
initial transponder 12457000 V 20000000 5
initial transponder 12472000 H 20000000 5
initial transponder 12486000 V 20000000 3
initial transponder 12501000 H 20000000 5
initial transponder 12516000 V 20000000 5
>>> tune to: 12239:h:0:20000
WARNING: >>> tuning failed!!!
>>> tune to: 12239:h:0:20000 (tuning failed)
WARNING: >>> tuning failed!!!

etc... (I stopped it with a CTRL-C)