# /etc/rc.d/rc.inet1.conf
#
# This file contains the configuration settings for network interfaces.
# If USE_DHCP[interface] is set to "yes", this overrides any other settings.
# If you don't have an interface, leave the settings null ("").

# You can configure network interfaces other than eth0,eth1... by setting
# IFNAME[interface] to the interface's name. If IFNAME[interface] is unset
# or empty, it is assumed you're configuring eth<interface>.

# Several other parameters are available, the end of this file contains a
# comprehensive set of examples.

# =============================================================================

# Config information for eth0:
#IPADDR[0]="192.168.1.51"
#NETMASK[0]="255.255.255.0"
USE_DHCP[0]=""
DHCP_HOSTNAME[0]=""

# Default gateway IP address:
GATEWAY="192.168.1.1"

# Change this to "yes" for debugging output to stdout.  Unfortunately,
# /sbin/hotplug seems to disable stdout so you'll only see debugging output
# when rc.inet1 is called directly.
DEBUG_ETH_UP="yes"

## Example config information for wlan0.  Uncomment the lines you need and fill
## in your info.  (You may not need all of these for your wireless network)
IFNAME[1]="wlan0"
IPADDR[1]="192.168.1.52"
NETMASK[1]="255.255.255.0"
WLAN_ESSID[1]=philemon
WLAN_MODE[1]=Managed
WLAN_RATE[1]="54M auto"
WLAN_CHANNEL[1]="10"
##WLAN_KEY[1]=""
#WLAN_IWPRIV[1]=""
WLAN_WPA[1]="wpa_supplicant"
WLAN_WPADRIVER[1]="wext"