b43-phy0: Broadcom 4306 WLAN found
b43-phy0 debug: Found PHY: Analog 2, Type 2, Revision 2
b43-phy0 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 2
b43-phy0 debug: DebugFS (CONFIG_DEBUG_FS) not enabled in kernel config
phy0: Selected rate control algorithm 'simple'
AC'97 1 does not respond - RESET
AC'97 1 access is not valid [0xffffffff], removing mixer.
Unable to initialize codec #1
intel8x0_measure_ac97_clock: measured 55550 usecs
intel8x0: clocking to 48000
Adding 1020116k swap on /dev/hda4.  Priority:-1 extents:1 across:1020116k
b43-phy0 debug: Loading firmware version 351.126 (2006-07-29 05:54:02)
b43-phy0 debug: Chip initialized
b43-phy0 debug: 30-bit DMA initialized
b43-phy0 debug: Wireless interface started
HW CONFIG: channel=1 freq=2412 phymode=2
b43-phy0 debug: Adding Interface type 2
ADDRCONF(NETDEV_UP): wlan0: link is not ready
HW CONFIG: channel=1 freq=2412 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=2 freq=2417 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=3 freq=2422 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=4 freq=2427 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=5 freq=2432 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=6 freq=2437 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=7 freq=2442 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=8 freq=2447 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=9 freq=2452 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=10 freq=2457 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=11 freq=2462 phymode=2
phy0: TX to low-level driver (len=42) FC=0x0040 DUR=0x0000 A1=ff:ff:ff:ff:ff:ff A2=00:90:4b:9a:cd:70 A3=ff:ff:ff:ff:ff:ff
HW CONFIG: channel=1 freq=2412 phymode=2