=== BUFFALO LS-GL U-Boot. ===
 ** LOADER **
 ** BUFFALO BOARD: BUFFALO_BOARD_LS_GL LE (CFG_ENV_ADDR=fffff000)


U-Boot 1.1.1 (Apr 18 2007 - 18:35:44) Marvell version: 1.12.1 - TINY

DRAM CS[0] base 0x00000000   size 128MB 
DRAM Total size 128MB 
[256kB@fffc0000] [0kB@f8000000] ## Unknown FLASH at f8000000: Size = 0x00000000 = 0 MB
Flash: 256 kB
Addresses 20M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (20M - 16M): Done

Soc: 88F5182 A2
CPU: ARM926 (Rev 0) running @ 400Mhz 
Orion 1 streaming disabled 
SysClock = 200Mhz , TClock = 166Mhz 


USB 0: host mode
USB 1: host mode
PCI 0: PCI Express Root Complex Interface
PCI 1: Conventional PCI, speed = 33000000
Net:   egiga0 [PRIME]
Using 88E1118 phy

Marvell Serial ATA Adapter
Integrated Sata device found
  Device 0: OK
Model: WDC WD2500JD-00HBC0                      Firm: 08.02D08 Ser#:      WD-WCAL77520516
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)

Using device ide0, partition 1

Loading from block device ide device 0, partition 1: Name: hda1
  Type: U-Boot  File:/initrd.buffalo

4513613 bytes read
Using device ide1, partition 1
** Bad partition 1 **
Booting from Device 0 
hit any key to switch tftp boot.
Hit any key to stop autoboot:  0 
Hit any key to stop autoboot:  0 

Reset IDE: 
Marvell Serial ATA Adapter
Integrated Sata device found
  Device 0: OK
Model: WDC WD2500JD-00HBC0                      Firm: 08.02D08 Ser#:      WD-WCAL77520516
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 238475.1 MB = 232.8 GB (488397168 x 512)

Using device ide0, partition 1

Loading from block device ide device 0, partition 1: Name: hda1
  Type: U-Boot  File:/uImage.buffalo

1809464 bytes read
Using device ide1, partition 1
** Bad partition 1 **
<<stop_sound>>
## Booting image at 00100000 ...
   Image Name:   Linux-2.6.16.16-arm1
   Created:      2007-06-29   2:14:44 UTC
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1809400 Bytes =  1.7 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK
## Loading Ramdisk Image at 00800000 ...
   Image Name:   initrd
   Created:      2007-07-09   0:06:04 UTC
   Image Type:   ARM Linux RAMDisk Image (gzip compressed)
   Data Size:    4513549 Bytes =  4.3 MB
   Load Address: 00000000
   Entry Point:  00000000
   Verifying Checksum ... OK

Starting kernel ...

arg:console=ttyS0,115200 root=/dev/sda2 rw initrd=0x00800040,15M panic=5 BOOTVER=1.10
CONFIG_BUFFALO_PLATFORM CONFIG_BUFFALO_LINKSTATION_LSGL ---
Uncompressing Linux..................................................................................................
Linux version 2.6.16.16-arm1 (root@develop) (gcc version 3.4.4 (release) (CodeSourcery ARM 2005q3-2)) #3 Fri Jun 29 7
CPU: ARM926EJ-Sid(wb) [41069260] revision 0 (ARMv5TEJ)
Machine: MV-88fxx81
Using UBoot passing parameters structure
Sys Clk = 200000000, Tclk = 166664740


- Warning - This LSP release was tested only with U-Boot release 1.7.3