usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
scsi 0:0:0:0: Direct-Access     MAXTOR S TM3250820AS      E    PQ: 0 ANSI: 2 CCS
sd 0:0:0:0: [sda] 488397168 512-byte hardware sectors (250059 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 38 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
sd 0:0:0:0: [sda] 488397168 512-byte hardware sectors (250059 MB)
sd 0:0:0:0: [sda] Write Protect is off
sd 0:0:0:0: [sda] Mode Sense: 00 38 00 00
sd 0:0:0:0: [sda] Assuming drive cache: write through
 sda:<6>usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 255 ret -110
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 10 ret -110
usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: device descriptor read/64, error -71
usb 1-1: device descriptor read/64, error -71
usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: device descriptor read/64, error -71
usb 1-1: device descriptor read/64, error -71
usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: device not accepting address 3, error -71
usb 1-1: reset high speed USB device using ehci_hcd and address 3
usb 1-1: device not accepting address 3, error -71
usb 1-1: USB disconnect, address 3
sd 0:0:0:0: Device offlined - not ready after error recovery
sd 0:0:0:0: [sda] Result: hostbyte=0x05 driverbyte=0x00
end_request: I/O error, dev sda, sector 0
Buffer I/O error on device sda, logical block 0
sd 0:0:0:0: rejecting I/O to offline device
Buffer I/O error on device sda, logical block 0
ldm_validate_partition_table(): Disk read failed.
sd 0:0:0:0: rejecting I/O to offline device
Buffer I/O error on device sda, logical block 0
 unable to read partition table
sd 0:0:0:0: [sda] Attached SCSI disk
sd 0:0:0:0: Attached scsi generic sg0 type 0
usb-storage: device scan complete
usb 1-1: usbfs: USBDEVFS_CONTROL failed cmd lsusb rqt 128 rq 6 len 4 ret -108
usb 1-1: new high speed USB device using ehci_hcd and address 4
usb 1-1: device descriptor read/64, error -71
usb 1-1: device descriptor read/64, error -71
usb 1-1: new high speed USB device using ehci_hcd and address 5
usb 1-1: device descriptor read/64, error -71
usb 1-1: device descriptor read/64, error -71
usb 1-1: new high speed USB device using ehci_hcd and address 6
usb 1-1: device not accepting address 6, error -71
usb 1-1: new high speed USB device using ehci_hcd and address 7
usb 1-1: device not accepting address 7, error -71