=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2008.04.23 13:05:19 =~=~=~=~=~=~=~=~=~=~=~=
RomBOOT

>

U-Boot 1.1.4.2 (Apr 22 2008 - 17:56:01)

DRAM:  32 MB
NAND:128 MiB
In:    serial
Out:   serial
Err:   serial
DP83848C PHY Detected

Hit any key to stop autoboot:  3  2  1  0 
TFTP from server 192.168.1.5; our IP address is 192.168.1.25
Filename 'uImage'.
Load address: 0x21400000
Loading: *#################################################################
	 #################################################################
	 #################################################################
	 #################################################################
	 ####
done
Bytes transferred = 1350620 (149bdc hex)
## Booting image at 21400000 ...
   Image Name:   linux-2.6
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1350556 Bytes =  1.3 MB
   Load Address: 20008000
   Entry Point:  20008000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK

Starting kernel ...

Uncompressing Linux......................................................................................... done, booting the kernel.
Linux version 2.6.24 (baranek@icsdcdc) (gcc version 4.0.0 (DENX ELDK 4.1 4.0.0)) #11 Wed Apr 23 12:25:17 CEST 2008
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
Machine: Atmel AT91SAM9260-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 198 MHz, master 99 MHz, main 18.432 MHz
CPU0: D VIVT write-back cache
CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 8128
Kernel command line: root=/dev/nfs rw nfsroot=192.168.1.5:/tftpboot ip=192.168.1.25:192.168.1.5:192.168.1.1:225.255.255.0:Arm9260:eth0:off console=ttyS0,115200 panic=5
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 32MB = 32MB total
Memory: 29604KB available (2476K code, 242K data, 116K init)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 64 bytes
NET: Registered protocol family 16
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
Time: pit clocksource has been installed.
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NetWinder Floating Point Emulator V0.97 (double precision)
JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL
RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize
loop: module loaded
ssc ssc.0: Atmel SSC device at 0xc2870000 (irq 14)
MACB_mii_bus: probed
eth0: Atmel MACB at 0xfffc4000 irq 21 (00:50:c2:4d:13:00)
eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffffff:00, irq=-1)
Driver 'sd' needs updating - please use bus_type methods
NAND device: Manufacturer ID: 0x20, Chip ID: 0xf1 (ST Micro NAND 128MiB 3,3V 8-bit)
AT91 NAND: 8-bit, Software ECC
Scanning device for bad blocks
Bad eraseblock 406 at 0x032c0000
Bad eraseblock 626 at 0x04e40000
Creating 5 MTD partitions on "at91_nand":
0x00000000-0x00020000 : "Bootstrap"
0x00020000-0x00060000 : "U-Boot"
0x00060000-0x00080000 : "U-Boot Env."
0x00080000-0x04000000 : "Linux"
0x04000000-0x08000000 : "Free space"
usbmon: debugfs is not available
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
udc: at91_udc version 3 May 2006
mice: PS/2 mouse device common for all mice
Registered led device: ds5
Registered led device: ds1
usbcore: registered new interface driver usbhid
drivers/hid/usbhid/hid-core.c: v2.6:USB HID core driver
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
IP-Config: Unable to set interface netmask (-22).
Looking up port of RPC 100003/2 on 192.168.1.5
eth0: link up (100/Full)
rpcbind: server 192.168.1.5 not responding, timed out
Root-NFS: Unable to get nfsd port number from server, using default
Looking up port of RPC 100005/1 on 192.168.1.5
rpcbind: server 192.168.1.5 not responding, timed out
Root-NFS: Unable to get mountd port number from server, using default
mount: server 192.168.1.5 not responding, timed out
Root-NFS: Server returned error -5 while mounting /tftpboot
VFS: Unable to mount root fs via NFS, trying floppy.
VFS: Cannot open root device "nfs" or unknown-block(2,0)
Please append a correct "root=" boot option; here are the available partitions:
1f00        128 mtdblock0 (driver?)
1f01        256 mtdblock1 (driver?)
1f02        128 mtdblock2 (driver?)
1f03      65024 mtdblock3 (driver?)
1f04      65536 mtdblock4 (driver?)
Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(2,0)
Rebooting in 5 seconds..RomBOOT

>